|
Vacuum Lifters | Tilters | Custom Manual Tilter
MT4FS818DCS
(This vacuum lifter is pictured with
optional vacuum pads and optional pad frame extensions.)
This versatile, DC-powered, manual tilter was
specifically designed for lifting long sheets of cladding material. Manufactured to
meet the needs of King Span Cladding in Europe, this vacuum lifter can be ordered with a 183-3/4 in. [4668 mm] pad spread, enabling it to lift long cladding that weighs up to
700 lbs [320 kg]. With a dual vacuum system, vacuum reserve tanks, and
versatile pad configuration, it is designed to reduce the risk of falling loads,
which could result from breakage or other accidents that compromise one area of
the vacuum system. Loaded with features, this lifter meets CE Standard EN
13155, making it as functional in your backyard as it is across the Big Pond.
FEATURES:
-
Green lift light
indicates when vacuum level is sufficient for lifting maximum load weight -
Operator can visually identify when there is sufficient vacuum to lift at maximum capacity
-
Vacuum gauge
enables monitoring of vacuum levels in positive inches of HG and negative kPa
-
Operator can visually determine whether vacuum level is adequate for lifting
-
Vacuum reserve tank
helps prevent immediate vacuum loss in case of power failure -
This helps prevent unexpected load release
-
Vacuum line filter
prevents contaminants from blocking vacuum lines or damaging valves & pump -
Helps to prevent vacuum system failure and unnecessary damage to equipment
-
Spring-mounted vacuum pads
adjust orientation to match angle of load surface -
Promote ease of performance when attaching to loads
-
Dual
vacuum system features two vacuum line circuits, allowing the
vacuum lifter to maintain the
vacuum level for one circuit even if an unexpected vacuum loss occurs in the
other one.
-
Low
vacuum warning buzzer provides an audible alarm that warns the
operator whenever
the vacuum level is not sufficient for lifting the maximum load weight.
-
On-board
battery charger stays with the lifter so you can charge the battery
wherever you go.
-
Battery
energy gauge allows the operator to visually assess the current
energy level of the battery.
-
(Re)movable
vacuum pad mounts allows operator to remove vacuum pads and/or
reposition
them at various locations on the pad frame.
SPECIFICATIONS:
Standard Vacuum Pad Spread:
Minimum Width - 18" [458 mm]
Maximum Width - 44" [1116 mm]
Minimum Length - 18-1/4" [463 mm]
Maximum Length - 44-1/4" [1121 mm]
(Optional pad frame extensions can be added to increase overall length to 183-3/4" [4668 mm])
Number / Size of Vacuum Pads:
4 / 8" x 18" [203 x 457 mm] vacuum pads, with replaceable closed-cell foam insert
Load Capacity*:
Maximum - 700 lbs [320 kg]
Per-Pad - 175 lbs [80 kg]
(*On nonporous surfaces with up to 3/8" [9.5 mm] relief.
Please contact us for recommendations on other surfaces.)
Weight of Vacuum Lifter:
230 lbs [105 kg] (does not include optional pad frame extensions)
Operating Power:
12 volts DC, 21 amps
Charger Requirements:
240 volts AC, 50/60 hertz, 3 amps
Load Movement:
Manual tilt, 90° between upright and flat, with hydraulic damping and
automatic latching in the upright and flat positions (when desired)
Available Options:
Pad frame extensions
Removable control pendant
Remote control system
The MT4FS818DCS Cladding Lifter is sold in Europe and the United Arab Emirates exclusively by AKAWA GGR UNIC. In other locations, please contact your authorized dealer for pricing and delivery information.
|
Home
View for printing
Send to a colleague
