Wood’s Powr-Grip® is proud to announce the addition of yet another powerhouse to its growing line of vacuum lifting equipment–the DC-powered Cladding Lifter (model MTCL4FS818DCS).

This highly adaptable vacuum lifter is specifically designed to lift cladding materials. Specialized foam rubber vacuum pads conform to surface contours up to 3/8" [9.5 mm] in depth, typical of cladding materials. Operators can easily remove, rotate and reposition vacuum pads, as needed to obtain optimal support of the materials. Additionally, the Cladding Lifter features 90° manual tilt with hydraulic damping and automatic latching (when desired) to transfer on-site materials easily from the flat position to the upright position, or vice versa.

Optional pad frame extensions can be added to augment the Cladding Lifter's versatility in handling a variety of materials. It has a standard load capacity of 700 lbs [320 kg] and, with optional extensions installed, can be configured to stretch to 183-3/4 inches [4678 mm] in length.

The Cladding Lifter also comes generously equipped with a full complement of standard features: A dual vacuum system with vacuum reserve tanks reduces the risk of falling loads, which could result from breakage or other accidents that may compromise one area of the vacuum system. An on-board battery charging system stays with the lifter so you can charge the battery wherever you go. The battery energy gauge allows the operator to visually assess the current energy level of the battery and a low vacuum level buzzer sounds an audible alarm that warns the operator whenever the vacuum level is not sufficient for lifting the maximum load weight.

To obtain information about the Cladding Lifter, visit our website or contact one of our Technical Sales Representatives by calling 800-548-7341.

The MTCL4FS818DCS Cladding Lifter is sold in Europe and the United Arab Emirates exclusively by AKAWA GGR UNIC. In other locations, please contact your authorized dealer for pricing and delivery information.

David Peters has more than 30 years experience in sales and marketing. He is currently the marketing associate for Wood’s Powr-Grip Co., Inc., responsible for interactive marketing, tracking, market research and new product introduction.